Nevoks Feelin 2 Pod Kit

Nevoks Feelin 2 Pod Kit

1. Fill the E-liquid
Uncover the silicone plug at the side of the pod and fill the e-liquid.
After filling, please wait for 5 minutes before using.
2. Device Operations
2.1 Power ON/OFF:
ON: In the power-off state, press the power button 5 times continuously within 2 seconds, and the RGB indicator flashes once from red-blue-green;
OFF: In the power-on state, press the power button again 5 times continuously within 2 seconds, and the RGB indicator flashes once from green-blue-red.
2.2 Vaping Mode:
Auto-Draw & Power Button. The RGB indicator will gradually light up and fade out. The color of the RGB indicator is displayed according to the battery level.
2.3 Power Button Auto-Standby:
When the device is powered on, if no operation within 1 minute, the power button will enter standby mode, the device works only in Auto-draw mode in the first puff, and the power button will be activated again.

Turn off the device and turn it on again, if no operation within 1 minutes, the power button will enter standby mode.
In the following conditions, the power button will not enter standby mode: Low voltage/no atomizer/short circuit, plugin/unplug pods or USB, adjust voltage and charging.

2.4 RGB Indicator Display State:
Vaping over 2.5 seconds, the RGB indicator will show 6 groups of different colors.

2.5 Voltage Adjustment:
In the power-on state, press the power button three times to
enter the adjustment mode. Level 1 RGB indicator is red for 3.2V; Level 2 is blue for 3.4V; Level 3 is on green for 3.6V (below 0.6Ω is 3.5V); After reaching level 3, the cycle goes to level 1.
2.6 Pod Identification:
In the power-on state, install the Pod into the device, the RGB indicator flashes white.
3. Charge Management and Battery Power
3.1 Charge Wake up:
Plugging in the USB, the indicator flashes once from red-blue-green.
3.2 Charging State:
The RGB indicator shows battery levels when charging: When over 4.15V (90 - 100%), the light stays green for 5 minutes before off.
3.3 Pass-through:
The device can be working while charging.

3.4 Finish Charging:
Remove the USB, the indicator is off.